Panasonic SL-CT790 - Manual (Page 4)

4
Sequential Play
Basic Play
1 2
3
4
5
PO RTA BLE
C D PLA
YER
SL-CT790
OPEN
CHG
VOL
HO LD
OPEN
EQ MODE MEMORY
Remote control
HOLD
HOLD
HOLD
S-XBS
MODE MEMORY
Remote control
VOL
S-XBS VOL
MODE MEMORY
Remote control
L R
Elapsed playing time of each track
Track number in play
Close the lid. Plug type:
3.5 mm
(1/8 in.) stereo
Decrease Increase
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and
CD-RW that have been finalized
§ upon completion
of recording. It may not be able to play some CD-R
or CD-RW due to the condition of the recording.
§ Finalizing is a process that enables CD-R/CD-RW players
to play audio CD-R and CD-RW.
Follow steps 1–5.
In step 2: Connect the stereo headphones/earphones
and wired remote control to the headphone
jack [Ë]. (Plug in firmly.)
In step 5: ≥The volume range is 0-25. (Press and hold
to change the volume successively.)
In step 5: ≥ The volume changes when pressed while
the level is displayed. If any other display is
shown, it changes to show the current level.
(The volume returns to 10 when you dis-
connect the power source.)
Note !
≥ Play stops automatically when all the tracks have
been played.
≥ If the unit has been connected to the car audio sys-
tem, set this unit’s volume to 10, then adjust the vol-
ume level on the system.
Auto-off function
If you leave the unit in stop mode for about 10 minutes,
(30 seconds if a disc is not loaded) it turns off to save
the batteries.
Resume function
The player stores the track where you stopped play and if
you press [1/;] (main unit) or [1/∫] (remote control),
play resumes from the beginning of that track.
Note !
≥ Opening the lid while in the stop mode or replacing
the disc while in the off mode cancels the function. (It
may remain active if you replace a disc in the off
mode.)
≥ Play may resume from the beginning of the next track
if you stopped play near the end of a track.
≥ The resume function is automatic and you cannot turn
it off.
For your reference:
“
) ” indication
This indication appears for about 30 seconds if [1/;]
(main unit) or [1/∫] (remote control) is pressed when
no disc is loaded in the unit or if the disc is not properly
secured.
“*” indication
This indication appears for about 10 minutes when the
lid is opened. (However, the indication does not appear
when the unit is powered off.)
Removing discs
1 Press [∫] to stop play and disc rotation.
2 Slide [OPEN] to open the lid.
3 Once the disc has stopped, lift the disc
out with your finger in the depression.
Do not stop the disc by hand or try to remove it before it
stops rotating. This can damage CDs.
Note !
Never insert foreign objects into the unit.
Increase
Decrease
(Beep)
Depression
(Beep)
(Beep)
Label must face
upward. Press
near the center so
the disc clicks
firmly into place.