Panasonic AW-RP400 - Manual (Page 11)

Indoor Pan/Tilt Head AW-PH400
AW-PH400
11
Parts and their function
J Y connector [Y]
This is the output connector for the camera’s video
signals.
It is connected to the Y/VIDEO connector on the
AW-RC400 cable compensation unit or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
The AW-PB302 RGB card must be installed if the
AW-E300, AW-E300A, AW-E600, AW-E800 or
AW-E800A convertible camera is to be used.
K 1394 connector [1394]
This is used for the control of the convertible camera and
pan/tilt head equipped with an IEEE1394 card such as
the AW-PB310.
Use an IEEE1394 cable for the connecting cable.
L SDI connector [SDI]
This is the output connector for the camera’s video
signals.
When the AW-PB504 SDI card or other card is inserted in
the convertible camera for use, SDI signals can be
output.
Use a BNC coaxial cable for the connecting cable.
M G/L IN connector [G/L IN]
This is the genlock signal input connector.
It is connected to the G/L OUT connector on the
AW-RC400 cable compensation unit or other unit.
Use a BNC coaxial cable for the connecting cable.
N PROMPTER IN connector [PROMPTER IN]
The video signals for the prompter are input to this
connector.
Use a BNC coaxial cable for the connecting cable.
O Pb connector [Pb]
This is the output connector for the camera’s video
signals.
It is connected to the Pb connector on the AW-RC400
cable compensation unit or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
P Pr/C connector [Pr/C]
This is the output connector for the camera’s video
signals.
It is connected to the Pr/C connector on the AW-RC400
cable compensation unit or monitor, etc.
Use a BNC coaxial cable for the connecting cable.