Panasonic AW-RP400 - Manual (Page 12)

Indoor Pan/Tilt Head AW-PH400
12
Installation
(Be sure to ask your dealer to install the unit.)
For a stand-alone installation
For installation on the ceiling
$ Assembling the pan/tilt head
When assembling the pan/tilt head, use the Allen key (provided) and screwdriver, and secure the head by tightening the screws
firmly. After mounting the pan/tilt head, check there is no play in its installation.
1 Attaching the camera mounting base
Attach the camera mounting base to the rotary arm using the three mounting screws (M5 ! 22 mm, with flat washers)
provided. The installation direction differs depending on how the base is installed.
2 Attaching the rotary arm
Attach the rotary arm to the rotary head using the four mounting screws (M5 ! 22 mm, with flat washers) provided.
The installation direction differs depending on how the arm is installed.
Camera mounting base
Rotary arm
Change the positions of the
camera mounting screws.
Rotary arm
Rotary head
Camera mounting base
Rotary head
Change the guide pin and screw positions as shown in the figure below on the right, and then attach the camera mounting
base to the rotary arm.
Camera Mounting base
Change the positions
of the guide pins.