Pioneer PRO-730HDI - Manual (Page 55)

55
BASIC FUNCTIONS
PICTURE ADJUSTMENTS
OTHER PICTURE QUALITY ADJUSTMENTS
The following six fine adjustments are available.
1 PureCinema ............ This function automatically detects movie film
recorded at 24 frames per second, and converts
it into a high quality 30 frames per second
delivering the picture at the same rate as it was
recorded.
2 COLOR TEMP ......... This function enables the image to be set to five
different tones.
3 3D Y/C LEVEL .......... Perform this adjustment when noises appear at
the color borders of the image.
4 3D NR LEVEL .......... Reduces the noise level of the luminance and
chrominance signals.
5 SVM (Scan Velocity Modulation)
............................... Screen contour definition can be selected as
desired.
6 FLESH TONE .......... By the time video signals from a broadcast station
arrive at your projection monitor (on air or cable
TV), they have experienced significant
degradation.
Flesh tone reduces color noise, improves color
uniformity and corrects unnatural flesh tones to
give your natural images.
7 BLACK ENHANCE ... Changing the black part of the video signal
automatically corrects the gradation of the black.
8 SHARP EFFECT ....... This enables you to switch the SHARPNESS
correction function.
9 LTI (Luminance Transient Improvement)
............................... This enables you to switch the definition of the
luminance signal.
0 GAMMA ................. This enables you to switch the balance of the
contrast between the bright parts and dark parts
of the luminance signal.
- CONTRAST EXP ..... This enables you to adjust the brightness level of
dark areas in accordance with screen brightness.
= SHARP MODE ........ This enables you to switch signal bands in order
to correct sharpness.
~ WHITE BALANCE ... This enables you to adjust the color temperature
to your taste.
NOTE:
Adjustments LTI, GAMMA, CONTRAST EXP, SHARP MODE and WHITE
BALANCE can be done only in PRO mode.
NOTES:
• The COLOR TEMP, GAMMA and WHITE BALANCE
settings may be changed when receiving RGB
input.
• In PURE DIGITAL: OFF state during digital signal
input (INPUT 5, 6) it is possible to switch between
4 and 9.
1
Press MENU and select PICTURE .
(Refer to page 26.)
2
Select .
MENU END SET SET
C O N T R A S T 3 0
B L A C K L E V E L 1 5
– 5
0 C O L O R
T I N T
SELECT
P I C T U R E
c c
M O D E : U S E R ( S T D )
S H A R P N E S S – 3 0 (To the following item.)
ARB1557A_En_052_063.P65 8/8/03, 16:52 55