Philips STEREO WIRELESS HEADPHONE HC850 - Manual (Page 8)

7 Adjust the volume to the desired level with
the headphone volume control.
Option 2 (figure 5)
Connecting the FM transmitter to a
headphone output of an audio source
IMPORTANT
Use only 1 of the audio inputs:
3.5 mm stereo headphone audio input
OR the line audio input!
Using both audio inputs at the same
time may damage your FM wireless
system or your audio source!
1 Connect the 2 RCA plugs of the stereo
audio cable to the FM transmitter’s audio
input 2:
– Check if the red RCA plug (right
channel) is connected to the right
channel (red) of the FM transmitter’s
audio input 2.
– Check if the white RCA plug (left
channel) is connected to the left channel
(white) of the FM transmitter’s audio
input 2.
2 Connect the 3.5mm stereo plug of the
stereo audio cable to the headphone
output of an audio source, such as TV, HiFi
or PC.
– In case your audio source has a 6.3 mm
headphone output, use the supplied
3.5 mm to 6.3 mm stereo adapter plug.
3 Switch on your audio source and carefully
increase the volume of the audio source.
The red power indication LED of the
transmitter lights up if receiving an audio
signal.
4 Switch on the headphone.You may hear a
hissing sound through the headphone if the
headphone is not yet properly tuned to the
transmitter.
5 To tune, press and hold the tuning control
button for about 1 second. Repeat if
necessary until the red tuning indication
lights up.
6 Adjust the volume to the desired level with
the headphone volume control.
Basic operation
When the FM transmitter is connected to a:
- line output of an audio source, such as
REC OUT or LINE OUT or
- headphone output of an audio source.
1 Switch on your audio source and carefully
increase the volume of the audio source.
The red power indication LED of the
transmitter lights up if receiving an audio
signal.
2 Switch on the headphone.You may hear a
hissing sound through the headphone if the
headphone is not yet properly tuned to the
transmitter.
3 To tune, press and hold the tuning control
button for about 1 second. Repeat if
necessary until the red tuning indication
lights up.
4 Adjust the volume to the desired level with
the headphone volume control.
5 Push the SRS™ on/off button to switch the
SRS™ surround sound mode on or off.
Audio Connections Basic operation
8
English
XP SBC HC 850/00 15-03-2002 11:50 Pagina 8