Perle Systems Speed LE 1P - Manual (Page 28)

Page 28
Chapter 2 Installing Drivers and Host Cards
3. Insert the SPEED LE or SPEED LE Express card you want to install into a vacant host
PCI card slot and secure in place as shown in the next picture.
4. Repeat step 3. until you have installed all the SPEED LE or SPEED LE Express cards
you want.
5. Replace and secure the system cover.
Installation of SPEED LE or SPEED LE Express cards is now complete.
Installing Cables and Connector Boxes
This section describes the mechanical installation of cables and connector boxes to the
SPEED LE and SPEED LE Express host cards for 1, 2, 4, and 8 ports and includes the
following;
• Installing cables on SPEED1 LE, SPEED2 LE, and SPEED4 LE cards on page 28 .
• Installing Fan-out Cables and Connector Boxes on SPEED4 LE HD and SPEED8 LE
HD Cards
on page 29 .
For information on available connectors and their pinouts and cabling, see Chapter 3
Cabling Information .
Installing cables on SPEED1 LE, SPEED2 LE, and SPEED4 LE cards
The SPEED1 LE has a D89M connector on the back panel.
The SPEED2 LE and SPEED4 LE each have RJ45 connectors on the back panel. There is
one for each serial port and they are labelled 1 to 4.
Caution
Full anti-static precautions should be taken when handling host
cards.