Pella Clad sliding patio door- southwestern wall with hard coat stucco 808SQ102 - Manual (Page 5)

5
REINSTALL THE SLIDING PANEL
TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE THE PANEL SAFELY.
x

A. Insert door panel. From the exterior of the building, tilt the top of the panel toward the door frame and
insert the top of the door panel into the top track. Move the bottom of the panel toward the door frame until
it is vertical. Gently set the panel down into the bottom track.
Architect Series: Adjust the panel clip and tighten the panel clip screw.
ProLine only: Install bumpers and the panel retainer. Follow the instructions included in the hardware box.
Note: Be careful not to pinch your fingers between the two panels. DO NOT close the sliding panel until
you have installed the hardware. The door may lock when closed.
B. Install the handles and panel retainer. Follow the instructions included in the hardware box. If the panel is not square to the door frame,
adjust the bottom rollers by removing the adjusting hole cover and inserting an 8" long #2 Phillips screwdriver into the hole. Turn clockwise
to raise the panel and counter-clockwise to lower the panel. Follow the instructions included in the handle box for final adjustments.
C. Install screen. Instructions for installing the screen are found in the screen door package.
6
INTERIOR SEAL
Caution: Ensure use of low pressure polyurethane window and door installation foams and strictly follow the foam manufacturer’s
recommendations for application. Use of high pressure foams or improper application of the foam may cause the door to bow and
hinder operation. DO NOT use fiberglass insulation.
Interior
6A
A. Apply insulating foam. From the interior, insert the nozzle of the applicator approximately 1" deep
into the space between the door and the rough opening and apply a 1" deep bead of foam. This will
allow room for expansion of the foam and will minimize squeeze out. If using foam other than Great
Stuff
™ Window and Door Insulating Foam Sealant by the Dow Chemical Company, allow the foam
to cure completely (usually 8 to 24 hours) before proceeding to the next step.
Note: DO NOT completely fill the space from the back of the fin to the interior face of the opening.
B. Check the door operation by opening and closing the door.
Note: If the door does not operate correctly, check to make sure it is still plumb, level, square and
that the sides are not bowed. If adjustments are required, remove the foam with a serrated knife.
Adjust the shims, and reapply the insulating foam sealant.
7 SEALING THE DOOR TO THE
EXTERIOR WALL CLADDING
Note: When applying the casing bead for stucco, leave 1/2" space
between the head of the door and the casing bead, and 3/8" space
between the door jambs and the casing bead for backer rod and
sealant. Refer to the illustration (Southwestern Wall With Stucco).
Note: The sealant details shown are standard recommendations
from the sealant industry. Contact your sealant supplier for
recommendations and instructions for this and any other application.
4065)8&45&3/
8"--
8*5)

456$$0

$MFBSBODF
#BDLFS
3PE
BOE
4FBMBOU
UZQJDBM
*OTVMBUJOH
'PBN
"DDFTTPSZ

(SPPWF