Philips Mercury Sable 1996-1999 - Manual (Page 7)

Wiring - 1
1. Remove the screws around the door speaker.
2. Remove the speaker from the door,
disconnect the speaker wire, and set the
speaker aside.
3. Guide the wire harnesses down into the door and bolt the mirror housing on the
door. On the inside of the door there are two small holes at the bottom of where
the plastic canister base is attached. The holes may be hidden behind foam
insulation. Guide the wire harness through the left hole and out of the door.
4. Pull the wire out between the door and door frame and remove any slack in the
wire.
1 2
3 4