Controls – Philips FW-V55 User Manual

Page 10

Advertising

3139 115 20042

English

CONTROLS

for CLOCK ..... to set the minute

(on

the system only).

) MIC LEVEL
–

to adjust the mixing level for karaoke
or microphone recording.

¡ MIC
–

to connect microphone jack.

™ VOLUME
–

to increase or decrease the volume.

£ DYNAMIC BASS BOOST (DBB)
–

to select a bass boost level or to
switch off bass boost.

≤ OPEN
–

to open tape deck 2.

∞ TAPE DECK 2
§ TAPE DECK 1
≥ OPEN
–

to open tape deck 1.

• OSD (ON SCREEN DISPLAY)
–

to switch on or off the on screen
display on the TV screen.

ª ZOOM
–

to enlarge a still picture on the TV
screen

(for VCD operation only).

º VOCAL
–

to fade out the vocal of the original
song during VCD playback or to switch
between mono or stereo mode during
audio disc playback

(for VCD operation

only).

⁄ KEY CONTROL (

I È i )

–

to change the key to suit your vocal
range

(for VCD operation only).

I ................. to decrease vocal key

level.

È .................... to restore vocal key to

original setting.

i ................... to increase vocal key

level.

¤ ECHO -/+
–

to adjust the echo level for karaoke
(for VCD operation only).

‹ RESUME
–

to continue playback again from
where you have stopped. Only when
PBC mode is switched off

(for VCD

operation only).

› SLOW
–

to watch a VCD at a slower speed.
There are 3 modes of selection

(for

VCD operation only).

ﬁ A - B
–

to playback a certain scene or passage
of a VCD/CD repeatedly.

ﬂ DIGEST
–

to scan through a VCD or a particular
track. There are 4 modes of selection
(for VCD operation only).

‡ REPEAT
–

to repeat a disc track or the current
disc.

° DIGIT 0 – 9

(numbers consisting more than two
figures must be keyed in within 2
seconds.)
for VCD with PBC on ..........................

to select an entry level.

for VCD/CD/MP3-CD…to key in a disc

track to start playback
or

...................... to select another track

during playback or

...................... to select a track for

programming.

· B
–

to switch the system to standby mode.

Notes for remote control:
– First select the source you wish to

control by pressing one of the
source select keys on the remote
control (e.g. VCD, TUNER, etc.).

– Then select the desired function

(Й, н, л, etc.).

pg 01-28/V55/21-En

6/8/01, 9:11 AM

Advertising