Philips PI7000/93 - Manual (Page 43)

44 EN
14 Check for
firmware update
Connect Pi7000 to Wi-Fi. You can receive
QRWLÀFDWLRQV DERXW ÀUPZDUH XSGDWHV &KHFN
QRWLÀFDWLRQV DW WKH EDVH RI WKH VFUHHQ VHH
8VH
WKH QRWLÀFDWLRQV DQG VWDWXV EDU
RQ SDJH  
<RX FDQ XSGDWH WKH ÀUPZDUH RI Pi7000
‡ on the device, or
‡ through Philips Device Manager.
8SGDWH WKH ÀUPZDUH RQ WKH
device
On Pi7000 \RX FDQ XSGDWH WKH ÀUPZDUH
through Philips online services over the Internet
(see 'System updates' on page 42).
8SGDWH WKH ÀUPZDUH WKURXJK
Philips Device Manager
You can use the by-packed Philips Device
Manager WR XSGDWH WKH ÀUPZDUH
Install Philips Device Manager
1
Connect Pi7000 to a PC by using the USB
cable.
2
On the PC, under My Computer or
Computer,
‡
ÀQG DQG FOLFN Pi7000;
‡ double click the installer.exe to start
installation.
3
Follow the onscreen instructions to
complete installation.
&KHFN IRU DQG XSGDWH WKH ÀUPZDUH
1
Make sure that your PC is connected to
the Internet.
2
Connect Pi7000 to the PC.
3
On your PC, launch Philips Device
Manager.
4
Click Update.
» Philips Device Manager checks for
XSGDWHV DQG LQVWDOOV QHZ ÀUPZDUH
from the Internet, if available.
5
When Update completed is displayed, click
OK.
6
Disconnect Pi7000 from the PC.
» Pi7000 UHVWDUWV DIWHU WKH ÀUPZDUH LV
updated and is ready for use again.
Note
‡ .HHS WKH GHYLFH SRZHUHG RQ EHIRUH WKH ÀUPZDUH
update is complete.