Precor C940 - Manual (Page 2)

C O M M E R C I A L P R O D U C T S D I V I S I O N
1. To properly mount the lower handrail clamp, you need to install a nut plate
into the guide rail. Remove the end cap from the rear of the treadmill using
a Phillips head screwdriver. See Diagram 1.
Important: If you are installing both handrail options, avoid misalignment of
the finger guard by sliding the nut plate into position on one side of the
treadmill and replace the end cap before removing the other end cap.
2. With the nut plate installed and the end cap replaced, move to the front of
the treadmill.
Installing the nut plate
into the guide rail.
Diagram 1
End cap
3. Locate the end covers on the upper handrails. See Diagram 2. Using the
3/16" hex key remove the two rear handrail end covers (the “covers” are
large black washers). Discard the covers and the bolts. Replacement bolts
and clamps are in this option package.
Important: If you are installing both handrail options, install a handrail on
one side before proceeding to the other side of the treadmill. Attach the front
portion of the handrail first. This helps you determine where to position the
lower handrail clamp.
Electronic console
Bolt
End clamp
Center clamp
Handrail end cover
Upper frame
Finger guard
Rear roller
Bolt
Attaching the front
section of the handrail.
Diagram 2
Upright support
Handrail
Guide rail
Side rail
Nut plate