Panasonic AG-HSC1UP User Manual
Page 115
Others
115
VQT1F36
Problem
Check points
This unit cannot be
operated though
powered up.
This unit does not
operate normally.
≥The unit cannot be operated if the LCD monitor is not opened.
≥Press the RESET button. (
l 118) If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about 1 minute
and then reconnect the battery or AC adaptor. Then about 1 minute
later, turn on the power again. (Conducting the above operation
while the card is being accessed may damage the data on the
SD card.)
The remote control does
not function.
≥Has the button-type battery of the remote control run out?
# Replace it with a new button-type battery. (l 25)
The screen has changed
suddenly.
≥Has the demonstration started?
# If you set [DEMO MODE] to [ON] without inserting an SD card in
recording mode, the demonstration automatically starts.
Normally this should be set to [OFF]. Press the MENU button,
then select [SETUP]
# [DEMO MODE] # [OFF] and press the
cursor button.
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
≥If you set [SETUP]
> [DISPLAY] > [OFF], indications other than
warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted.
≥Has the SD card’s write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set to
LOCK. (l 27)
≥Is the memory of the SD card full?
# If there is no more available memory, free up some memory by
deleting unnecessary scenes or use a new SD card. (l 34, 74,
≥Is the unit set to recording mode?
# No recording is possible if the mode dial is set to other than
.
≥Is the card slot cover open?
# If the card slot cover is open, this unit may not operate normally.
Close the card slot cover.
The unit arbitrarily stops
recording.
≥Can the SD card be used for motion picture recording?
# Use an SD card that can be used for motion picture recording.
≥Is the AGS function activated?
# Record in the normal horizontal position or set [AGS] to [OFF].
VQT1F36_ENG_PP.book 115 ページ ２００７年２月２６日 月曜日 午前１１時２９分