Panasonic KX-TG2322 - Manual (Page 23)

For assistance, please call: 1-800-211-PANA(7262)
23
Special Features
T
elephone System
Re-registering the Handset
If an alarm tone sounds when you press [C], [SP-PHONE] or [VOICE
ENHANCER] even when using the handset near the base unit, the
handset may have lost communication with the base unit. You need to re-
register the handset to the base unit.
• Make sure the base unit is not being used.
• Have both the handset and base unit nearby during registration.
• Follow steps 1 and 2 listed below. You have about 1 minute to
complete them.
• If the handset beeps 3 times in step 2, an error occurred. Try again from
step 1.
• You can stop registration by pressing [OFF] on the handset, and pressing
[HANDSET LOCATOR] on the base unit.
1 Base unit:
Press and hold [HANDSET LOCATOR].
• The CHARGE indicator flashes.
2 Handset:
Press and hold [FLASH/CALL WAIT] until a beep sound.
• The VOICE ENHANCER indicator flashes.
• When registration is complete, a beep sounds from the handset and
the indicator lights go out.
• Wait for 20 seconds after registration is complete while the
handset establishes communication with the base unit.
Handset & Base Unit