Petsafe Dog Kennel - Manual (Page 6)

6 1-888-632-4453
Assemble the Gate
1. Gather 2 double corner rails, 2-65" tension rods, 1 piece chain link fabric and 8 clips.
2. Insert swedged end into plain tube for both double corner rails (5A).
3. Slip both tension rods down through the fi rst diamonds of the fabric on each side (5B).
4. On one side using 4 clips, connect the fabric to the gate frame by clipping the tension rod to the frame
(5C).
5. On opposite side using 4 clips, connect fabric to frame by placing clip on tension rod fi rst and then clip
onto frame by applying downward pressure (5E). Watch fi ngers as they can get pinched in this step.
Work gloves are recommended for this step.
6. Attach 2 tie wires to the bottom of the gate spaced evenly apart (5F). Attach 1 tie wire centered at the
top (5D).
5A
5B
5F
5D
5E
5C
__________________________________________________________________________________________________
Install the Gate
1. Gather male and female hinges, 4 - 3 /
8
" x 2" carriage bolts with nuts, and the gate. Note: Gate can open
from either side.
2. Install the upper female hinge below the upper most gate clip (6B).
3. Install the lower female hinge directly above the bottom gate clip (6C).
4. Position the gate centered in the gate opening.
5. Attach bottom male hinge and slide up to meet bottom female hinge. Tighten securely (6C).
6. Attach top male hinge and slide down to meet top female hinge. Tighten securely (6B).
7. With an adjustable wrench, install the gate latch 36" from the ground (6A). Note: The gate latch can be
locked. Lock not provided.
Step
6
Step
5