ProForm PFTL79007.0 - Manual (Page 9)

9
7. Press a Front Handrail Endcap (97) into the Left
Handrail (35). Attach the Front Handrail Endcap
with a #8 x 3/4" Handrail Screw (15).
Press an Upright Insert (110) into the Left
Upright (74). Set the Left Handrail (35) on the
Upright Insert.
Attach the Left Handrail (35) with two 3/8" x 1
1/4" Bolts (7) and two 3/8" Star Washers (9).
Firmly tighten the Bolts.
15
7
8. Hold the Right Handrail (33) near the Right
Upright (78). Insert the Upright Wire (38)
through an Upright Insert (110), into the hole in
the bottom of the Right Handrail (33), and out of
the large hole in the side of the Right Handrail.
Insert the included plastic tie through the holes
in the Right Handrail (33) as shown. Look inside
the Right Handrail.
Make sure that the plastic
tie holds the Upright Wire (38) to the side as
shown in the inset drawing. Tighten the plas-
tic tie.
Press a Front Handrail Endcap (97) into the
Right Handrail (33). Attach the Front Handrail
Endcap with a #8 x 3/4" Handrail Screw (15).
Attach the Right Handrail (33) with two 3/8" x
1 1/4" Bolts (7) and two 3/8" Star Washers (9).
Firmly tighten the Bolts.
8
9. Set the Console Base (93) face down on a soft
surface to avoid scratching the Console.
Remove the two indicated screws (A) from the
Pulse Bar Bottom (95). Discard the screws.
9
35
110
78
97
38
33
7
9
Plastic Tie
Large Hole
15
74
110
9
7
97
A
95
93
38
33
Tie
110
Hole
Hole