Philips VR621CAT - Manual (Page 9)

1
Make the connections shown above.
Rerecording (Tape Duplication) 37
3
VCR 2 will record your tape. Insert a blank tape in VCR 2.
The VCR must be in VCR position. (The VCR light will appear on
the display panel. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 03 or 04, whichever
channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press the VCR but-
ton, then press Number buttons 0, 0, 1 or 0, 0, 2. (See
Helpful Hints at right.)
6
Press the SPEED button to select SP or SLP at VCR 2.
7
Press the PLAY button on VCR 1 and the RECORD but-
ton on VCR 2 at the same time.
To stop recording, press the STOP/EJECT button on VCR 1, then
press the STOP/EJECT button on VCR 2.
2
VCR 1 will play your tape. Put a prerecorded tape in VCR 1.
• If you use the AUDIO and VIDEO IN
Jacks on the back of VCR 2, press
Number buttons 0, 0, 1. AV REAR
will appear on the TV screen. (BLUE
BACKGROUND should be set to ON.
Details are on page 46.)
• If you use the AUDIO and VIDEO In
Jacks on the front of VCR 2, press
Number buttons 0, 0, 2. AV FRONT
will appear on the TV screen. (BLUE
BACKGROUND should be set to ON.
Details are on page 46.)
• Unauthorized recording of copyright-
ed television programs, video tapes,
or other materials may infringe on
the rights of copyright owners and
violate copyright laws.
• If a program has copyright protection,
it may not record clearly.
• The VCR in the figure above is the
VR621CAT. If you have the
VR421CAT, use a single-plug audio
cable to connect the AUDIO OUT
jack on VCR 1 to the AUDIO IN jack
on VCR 2.
Helpful Hints
● Audio and Video cables are not supplied.
VCR 1
Playing VCR
VCR 2 - Recording VCR
1. Audio cables from AUDIO OUT Jacks
of VCR 1 to AUDIO IN Jacks of VCR 2
2. Video cable from VIDEO OUT Jack
of VCR 1 to VIDEO IN Jack of VCR 2
3. RF coaxial cable
from the OUT jack of
VCR 2 to the TV’s
ANTENNA IN Jack
The instructions on this page show you how to copy tapes. The illustration uses two VR621CAT VCRs. Different
VCRs may operate differently. To duplicate a tape, make the connections shown, then follow steps 1-7.