ProForm PFSY69520 User Manual
Page 12
21. Remove the pre-assembled 4” Pulley (not shown)
from the Pulley Bracket (91).
Attach the end of the Leg Press Cable (76) to the
Pulley Bracket (91) with a 1/4” Washer (71) and a
1/4” Nylon Locknut (25).
Lay the Pulley Bracket (91) and the Leg Press
Cable (76) aside; they will be attached in step
29.
21
71
25
91
76
20. Wrap the Leg Press Cable (76) around a 4”
Pulley (35). Attach the Pulley and a Cable Trap
(44) to the bracket on the Stabilizer (5) with a 3/8”
x 2” Bolt (62) and a 3/8” Nylon Locknut (50).
Be sure that the Cable Trap (44) is positioned
to hold the Cable in the pulley groove.
20
50
62
12
22. Locate the High Cable (73). Feed the bolt end of
the High Cable up through the indicated slot in
the Main Upright (3). Feed almost all of the Cable
through the slot.
Slide a 3/8” Washer (55) and a 5/8” x 1/2” Bushing
(42) onto a 3/8” x 2 1/2” Bolt (54).
Wrap the High Cable (73) around a 4” Pulley (35).
Hold the Pulley inside the indicated slot in the
Main Upright (3). Insert the 3/8” x 2 1/2” Bolt (54)
through the Main Upright and the Pulley.
Slide another 5/8” x 1/2” Bushing (42) and 3/8”
Washer (55) onto the 3/8” x 2 1/2” Bolt (54).
Tighten a 3/8” Nylon Jamnut (63) onto the Bolt.
22
Slot
35
73
55
54
42
55
3
42
63
35
76
5
44
Bracket