ProForm PFEX74207.1 - Manual (Page 19)

19
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 5 on page
7 for replacement instructions. If the handgrip pulse
sensor does not function properly, see step 5 on
page 13.
HOW TO LEVEL THE EXERCISE CYCLE
After the exercise
cycle has been
moved to the loca-
tion where it will
be used, make
sure that the ends
of both front stabi-
lizer are touching
the floor. If the
exercise cycle
rocks slightly dur-
ing use, turn one or both of the leveling feet under the
front stabilizers until the rocking motion is eliminated.
HOW TO MOVE THE EXERCISE CYCLE
To move the exercise cycle, hold the handle on the
rear stabilizer and carefully lift it until the exercise
cycle can be moved on the front wheels. Carefully
move the exercise cycle to the desired location and
then lower it.
Handle
Wheel
Leveling
Foot
MAINTENANCE AND TROUBLESHOOTING