Panasonic KX-TG5451 - Manual (Page 49)

Answering System Features
For assistance, please call 1-800-211-PANA (7262). 49
Answering system commands
You can also operate the answering
system by pressing dial keys.
To use the following commands, press
{
MENU}, then press {Select} at
“Message play”.
*1 If pressed within the first 5 seconds of a
message, the previous message will be
played.
*2 To resume operation, press a command
key within 15 seconds, or the voice
guidance will start.
Calling back (Caller ID subscribers
only)
If Caller ID information was received for
the call, you can call the caller back while
listening to a message.
Press {Call} during playback.
Note:
L To edit the number before calling back,
press {Edit} repeatedly to select the
desired format (page 29), then press
{
Call}, {C}, or {s}.
Memory capacity
The total recording capacity (including
your greeting message and caller
messages) is about 21 minutes. A
maximum of 64 messages (including a
greeting message) can be recorded.
L
If message memory becomes full:
– “
E” flashes on the base unit.
– the ANSWER ON indicator flashes
rapidly (if the answering system is
turned on).
– the unit announces “Memory full”
when operating the answering
system.
To record additional messages, erase
unnecessary messages.
L
If less than 3 minutes of recording time is
available, the unit will announce the
remaining recording time when
operating the answering system.
L Messages are retained even if a power
failure occurs. All messages are saved
until you erase them. (Flash memory
message backup)
L
The total recording capacity may be
reduced by the calling party’s
background noise.
Key Command
{
1} or { <} Repeat message (during
playback) *1
{
2} or { >} Skip message (during
playback)
{ 4} Play new messages
{ 5} Play all messages
{ 8} Turn answering system on
{ 9} Stop playback *2
{
0} Turn answering system off
{
CLEAR}
or {*}{4}
Erase this message (during
playback)
{*}{ 5} Erase all messages
TG5451_5452.book Page 49 Tuesday, November 16, 2004 9:03 PM