Using the remote control, Installing the unit, Plugging in – Pioneer XW-NAS5 User Manual

Page 7: Before you start 01

Advertising
background image

Before you start

01

7

En

English

Français

Deutsch

Nederlands

Italiano

Español

• Remove the battery if the unit isn’t going to

be used for a month or more.

• When disposing of used batteries, please

comply with governmental regulations or
environmental public instruction’s rules
that apply in your country or area.

•

WARNING
Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.

“ Perchlorate Material – special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate.
(Applicable to California, U.S.A.) “

Using the remote control

The remote has a range of about 7 m (23 ft.) at
an angle of about 30º from the remote sensor.

Keep in mind the following when using the
remote control:

• Make sure that there are no obstacles

between the remote and the remote sensor
on the unit.

• Remote operation may become unreliable

if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.

• Remote controllers for different devices

can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.

• Replace the batteries when you notice a fall

off in the operating range of the remote.

Installing the unit

• When installing this unit, make sure to put

it on a level and stable surface.

Don’t install it on the following places:
– on a color TV (the screen may distort)
– near a cassette deck (or close to a device that
gives off a magnetic field). This may interfere
with the sound.
– in direct sunlight
– in damp or wet areas
– in extremely hot or cold areas
– in places where there is vibration or other
movement
– in places that are very dusty
– in places that have hot fumes or oils (such as
a kitchen)

Plugging in

After you’ve finished making all connections,
plug the unit into an AC outlet.

1

Plug the supplied power cord into the AC

IN socket on the back of the unit.

2

Plug the other end into a power outlet.

Important

• Before making or changing any

connections, switch off the power and
disconnect the power cord from the AC
outlet.

30°

30°

7 m (23 ft.)

AUDIO IN

AC IN

FM UNBAL 75

ANTENNA

XW-NAS5_CUXJ.book 7 ページ 2010年1月26日 火曜日 午後5時0分

Advertising