Polycom VoiceStation 100 - Manual (Page 10)

V
o
ic
e
Sta
tion 1
0
0
Ins
tallati
on Ins
tr
uc
tions and U
ser
’s Gui
de
6
No Dial Tone
▼ Check that all connections
are correct and tight.
▼ Make sure the short cable is connected
to a standard analog phone line.
▼ Try a different telephone line.
Telephone Does Not Ring
▼ Adjust the Ringer with the Volume Up
button.
Short Silences, Echoes,
or Clipped Speech
▼ Don’t move VoiceStation™100
while it’s in use.
▼ Keep your hands away from
the unit during calls.
▼ Keep papers, cups, coffee pots,
and other objects away from the unit.
▼ At the beginning of a call, allow
each speaker present to speak in turn
for a few moments to enable
VoiceStation 100’s electronics
to adjust to the acoustic environment.
▼ The other party may be using low
quality equipment or a half-duplex
conference bridge, in which case there
is little that you can do.
Muffled or "In a Well"
Reception
▼ Speak closer to the unit so the
microphones can pick up your speech.
▼ Add more sound absorbing surfaces to
the room, (carpets, curtains, etc.).
Excessive Noise
▼ Noisy equipment such as a computer,
or fan may make it difficult to hear
the other party. Both parties should turn
off noisy equipment.
▼ Try calling again to see if a different
line provides a better connection.
Physical Damage
▼ If physical damage causes internal
parts to become accessible, disconnect
VoiceStation 100 immediately.
Do not reconnect VoiceStation 100
to the network until it has been repaired
by a Polycom authorized repair center.
In Case of Difficulties
Maintenance
Clean equipment with a soft, dry cloth.
Do not use alcohol or petroleum-based
cleaners.