Pioneer Elite VSX-03TXH - Manual (Page 38)

Using the tuner 06
38
En
4 Press ENTER.
After pressing ENTER, the preset class and number stop
blinking and the receiver stores the station.
Naming station presets
For easier identification, you can name your station
presets.
1 Choose the station preset you want to name.
See Listening to station presets below for how to do this.
2 Press T.EDIT (Tuner Edit).
The display shows STATION NAME, then a blinking
cursor at the first character position.
3 Input the name you want.
Choose from the following characters for a name up to
four characters long.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!”#$%&’()
∗
+,–./:;<=>?@[ \ ]^_{|} ˜ [space]
Use
/ to select a character, / to set the position,
and ENTER to confirm your selection.
Tip
• To erase a station name, simply repeat steps 1 to 3
and input four spaces instead of a name.
• Once you have named a station preset, you can press
DISPLAY when listening to a station to switch the
display between name and frequency.
Listening to station presets
You will need to have some presets stored to do this. See
Saving station presets on page 37 if you haven’t done this
already.
1 Press FM/AM to select the tuner.
2 Press CLASS to select the class in which the station
is stored.
Press repeatedly to cycle through classes A, B and C.
3 Press ST / to select the station preset you
want.
• You can also use the number buttons on the remote
control to recall the station preset.
VSX-03TXH_KU.book Page 38 Thursday, March 27, 2008 8:56 PM