Panasonic TH37PR11UK - Manual (Page 9)

1
2
SERIAL PC IN
AUDIO
SLOT1 SLOT2 SLOT3
1 2
9
Connections
From SERIAL
Terminal on Computer
(see page 11) From EXTERNAL
monitor terminal on
Computer (see page 10)
AC cord connection (see page 12)
– AC cord fi xing
Optional Terminal
Board Insert Slot
(covered)
– Cable fi xing band
Secure any excess cables with band as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure. To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten:
To loosen:
Pull
Pull
Push the catch
Note:
Make sure that the AC cord is locked
on both the left and right sides.
Push until
t h e h o o k
clicks.
2. Pull off.
1. Keep the
knob
pressed.
Unplug the AC cord
Unplug the AC cord pressing
the two knobs.
Close
Open
1 Plug the AC cord into
the display unit.
Plug the AC cord until
it clicks.
2 Fix the AC cord with
the clamper which is
attached to the unit. Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet fi rst.
Note:
One fi xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.