Premier Mounts GearBox Equipment Enclosure GB-PLEN1 - Manual (Page 8)

Page 8 Installation Instructions
GB-PLEN1
Completed Attachment
Padlock Hasp
(optional)
M5 x 10mm
Screws
Step 6. Place the padlock hasp on the inside of the
GB-PLEN1
(optional).
Step 7. Use two (2) M5 x 10mm Phillips screws to attach
the padlock hasp to the GB-PLEN1.
Step 8. Place the cover lid onto the GB-PLEN1 and
secure using four (4) M5 x 10mm screws and
tighten with a Phillips head screwdriver.
When attaching the padlock hasp, make sure
the flat side is resting against the inside wall
of the GB-PLEN1.
The cover lid may be mounted facing either
direction.
M5 x 10mm
Screws
Cover Lid
Completed Installation
If you did not pre-install electrical components,
then you may now install all power and signal
equipment. A qualified electrician should make any
power connections to the GB-PLEN1.