Philips HTR5224 - Manual (Page 16)

16
Sync audio output with video play
1
Press SURROUND to switch to multi-
channel surround mode.
2
Press AUDIO SETUP .
3
Press / until ‘AUDIO SYNC’ is
displayed, then press OK .
4
Press VOL +/- within 5 seconds to set the
delay time for audio output.
To return to previous step, press •
BACK .
To exit the setup, press
• AUDIO
SETUP .
Tip
If the volume control is not adjusted within 10 •
seconds, it resumes normal volume control
function.
Set the speaker delay time
1
Press SURROUND to switch to multi-
channel surround mode.
2
Press AUDIO SETUP .
3
Press / to select the speaker for
which you want to set the delay time,
then press OK .
‘CENTER DELAY’ - for centre speaker. »
‘SURROUND DELAY’ - for surround »
speakers.
‘BACK DELAY’ - for back (rear)
»
speakers.
4
Press or adjust the volume control to
increase or decrease the delay time, then
press OK .
The last volume setting will be •
stored automatically after 5 seconds
of inactivity.
5
Repeat steps 3 - 4 for other speaker
settings.
To return to previous step, press •
BACK .
To exit the setup, press
• AUDIO
SETUP .
Note
This setting is only applicable to centre, back •
and surround speakers.
Set a longer delay time if the centre, back or •
surround speakers are closer to the listening
position than the front speakers.
Rear and centre delays range from 0 to 15 MS. •
The default setting is 0 MS.
EN