ProForm CrossTrainer PFTL59806.0 - Manual (Page 8)

7. Set the console assembly on the Handrail (20).
Be careful to avoid pinching any of the wires.
Make sure that the ground wire (see step 5)
and the wire from the console assembly (see
step 6) are in the indicated channel.
Hand tighten five Screws (3) into the Handrail
(20) and the console assembly.
Do not put
Screws into the two indicated holes. Start all
five Screws, but do not tighten them yet.
6. While the second person continues to hold the
console assembly, locate the wire underneath
the console assembly.
Connect the wire from the console assembly to
the Upright Wire Harness (77).
Make sure to
connect the connectors properly (see the
inset drawing). The connectors should slide
together easily and snap into place. If the con-
nectors do not slide together easily and snap
into place, turn one connector and then try again.
IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Insert the connectors downward
into the Handrail (20).
8
Console Assembly
3
3
No Screws
3
20
77 Console
Assembly
77
20
7
5. While a second person holds the console as-
sembly near the Handrail (20), attach the ground
wire to the indicated hole in the Handrail with a
Ground Screw (33).
20
Hole
Ground
Wire
Console
Assembly
33
5
6
Wire
Channel