Patton electronic 2702 G.703 - Manual (Page 4)

2.0 GENERAL INFORMATION
Thank you for your purchase of this Patton Electronics product.
This product has been thoroughly inspected and tested and is warrant-
ed for One Year parts and labor. If any questions arise during installa-
tion or use of the unit, contact Patton Electronics Technical Services at
(301) 975-1007.
2.1 FEATURES
• Converts Synchronous unframed 2 Mbps G.703 to V.35
• Integral V.35 (M/34) Male connector (6 Pin Cisco router also
available)
• V.54 Compliant Loopback Diagnostics
• Easy to Read LEDs for TXD, RSD, ALM, LOTC, TST, and ERR
• AMI or HDB3 Line Coding
• Configuration via DIP Switches
• External 100-240VAC Power Supply
2.2 GENERAL PRODUCT DESCRIPTION
The Patton Model 2702 fits into an environment where high-speed
E1/G.703 services are being offered to customers with Router/FRADS
and other networking devices. These G.703 Interface Converters are
required to convert signals from the unstructured, synchronous line
interface - delivered by the carrier - to a 2 Mbps digital interface
required by the users networking equipment.
To accomplish this, the Model 2702 presents a RJ48C interface to
the line and a V.35 interface to the customer’s device. The V.35 inter-
face is presented using a Male M/34 connector. Line coding and clock
options may be selected using internally accessible DIP Switches
If other interfaces are required, you may select our Model 2703 con-
verter which presents the following interfaces: X.21, RS422/530,
V.36/RS449 and V.24/RS232. These interfaces are delivered through a
standard interface cable which connects to the Female DB25 on one
end and the desired interface on the other end. If other DTE speeds
are necessary, our Model 2094 connects Fractional E1 at nx64 speeds
up to 2 Mbps. Please see the interface converter section of the Patton
Catalogue for the required converter.
5
2.3 SUPPORTED APPLICATIONS
The Model 2702 provides a E1 network termination between E1
and customer premises equipment (CPE) such as a router. The Model
2702 can also be used as a high-speed short haul modem for campus
applications.
2.3.1 The 2702 as the Interface between the Telco and CPE
The Model 2702 provides the interface between an E1 multiplexer
and a router or switch (See below).
2.3.2 The 2702 as a High-Speed Short Range Modem
The Model 2702 can also be installed into high-speed campus
applications. In this application, a pair of Model 2702 units operate as
short range modems (See below).
6
Model 2702 Model 2702
Internet
LAN
Model 2702
MUX DACS
E1/FE1
from
64kbps to
2.042Mbps
Customer Site Service Provider’s Network
Customer Site Service Provider’s Network