Prima LPR 712 - Manual (Page 6)

1Detergent dispenser drawer
2 Mains-on light
This light comes on when the “On/Off” button is
pressed, and goes out when it is pressed again.
3 “On/Off” button
Press this button to switch the machine on. Press it
again to switch the machine off.
Programme Option buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing the
desired programme and before pressing the
“Start/Pause” button.
When these buttons are pressed, the corresponding pilot
lights come on. When they are pressed again, the pilot
lights go out.
If an incorrect option is selected, the corresponding
pilot light flashes for a few seconds.
4 Spin” button
Press this button to reduce the maximum speed of the
final speed proposed by the machine for the selected
programme or to select position
“Rinse Hold” .
The light corresponding to the selected option
illuminates.
The following speeds are available for the different
fabrics:
• Cottons, linen: 500/700/900 max 1200 r.p.m.
• Synthetics and Handwash (wool):
500/700 max 900 r.p.m.
• Delicates and Mini:
500 max 700 r.p.m.
6
The Control Panel
1 2 3 4 5 9 6 7 8 10 11
Quick Prewash
Extra
Rinse
Easy
Iron
Start/
Pause
On/Off
Spin
1200
900
700
500 90° 90°Eco
60°Eco
40°Eco
40°
30°
Cold
60°
60°Eco
40° 40° 30°
40°
30°
Cold
Soak 30°
Rinse
Softener
Drain
Spin Mini Cottons
Synthetics
Delicates
Hand- wash
30° Cold
LPR 712
Rinse Hol
When Rinse Hold option is selected, the last rinse
water is not emptied out, to prevent the fabrics from
creasing. When the programme has finished, the door is
locked, the light of the “Start/Pause” button goes off,
the pilot lights “End” and “Rinse Hold” in the
programme progress display are alight to indicate that
the water must be emptied out.
There are two methods of draining the water from the
machine.
Method 1: Drain the water only, no spin:
• Turn selector dial to " o " position.
• Select the programme “Drain”.
The water will be emptied out without spinning.
Method 2: Drain and then spin the laundry:
• Turn selector dial to “ o ” position.
• Select programme “Spin”.
• Select the required spin speed (see 4 spin speed
button)
• Press Start/Pause button
The water will empty out and then the laundry will be
spun at the selected spin speed.
Attention! Before selecting programmes “Drain” or
“Spin”, the selector dial has to be positioned on “
o ”
(cancelling).
5 “Quick” button
This option can be used for lightly soiled Cotton,
Synthetic or delicate items that have been used or
worn for a short time.
This option is not available with the Handwash
(Wool) programme, the Energy saving programmes
(90° Eco, 60° Eco and 40° Eco) and Mini.
132967680.qxd 31/10/2007 14.40 Pagina 6