Philips DLV92009/10 - Manual (Page 5)

1
2
3
CD-ROM
4
5 AAA
88.5
3
2
1
4
5
AAA
88.5
3 2
1
4
5
AAA
1
Power Button
Press the Power Button once to power on
the TransCast FM. Press and hold button
for 3 seconds to turn off the TranCast FM.
Left/Right Buttons
Use the Left/Right Buttons to adjust the
TransCast FM frequency.
Preset Button
Use the Preset Button to save presets
and cycle through exisiting presets.
Audio Input
Plug the 3.5mm Connection Cable into
the headphone jack of the audio source
you wish to use.
4
3
2 2
1
2
3
4
Getting started
C Important: Read the “Important information” chapter
carefully before using your Philips TransCast FM.
This section helps you with installation of
your Philips TransCast FM for the first time.
1. Insert the included AAA Battery into the battery
compartment of the TransCast FM.
2. Plug the 3.5mm Connection Cable into the Audio-Out
(or headphone jack) of the audio source you wish to use.
Then, connect the other end of the cable to the Audio-In
Port on your TransCast FM.
3. Press the Power Button to turn on TransCast FM.
4. Tune your radio to an open FM frequency, and use the
Left/Right Buttons to tune the TransCast FM to the same
frequency. Then, press play on your portable audio device.
5. Adjust the volume on your portable audio device to achieve
the best sound quality. Then, control the overall volume using
your stereo.
D
Note: For best sound quality, setting your portable audio
device’s volume level between 60 and 80% is recommended.
8 9
EN
G
LI
SH