Caution – ProForm 831.297211 User Manual

Page 8

Advertising
background image

BATTERY INSTALLATION

The console requires three "AA" batteries (not in-
cluded). Alkaline batteries are recommended. Open
the battery cover as shown in the drawing at the upper
right. Insert three batteries into the battery compart-
ment, making sure that the negative (Ð) ends of the

batteries are touching the springs in the battery com-
partment. Close the battery cover, push up on the bat-
tery cover tab, and then push the tab forward as
shown in the inset drawing. Be sure that the tab locks
into place.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)

Next, step onto the foot
rails of the treadmill. Find
the clip attached to the key,
and slide the clip onto the
waistband of your clothing.

Follow the steps on the page 9 to operate the console.

8

CAUTION:

Before operating the

console, read the following precautions.

¥ Do not stand on the walking belt when

turning on the power.

¥ Always wear the clip (see the drawing at

the lower right) while using the treadmill.
When the key is removed from the console,
the walking belt will stop.

¥ Adjust the speed in small increments.

¥ The training zones marked beside the

speed control are general guidelines only.
See page 14 for more information.

¥ To reduce the possibility of electric shock,

keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.

Battery

Cover

Battery

Cover Tab

CONSOLE DIAGRAM

Note: If there is a thin sheet of clear
plastic on the face of the console,
remove it before operating the console.

LED Track

Clip

Batteries

Advertising