ProForm PFTL81405.0 - Manual (Page 7)

7
3. Insert a Wheel (93) into a Wheel Housing (43). Attach the
Wheel with a Wheel Bolt (92) and a Nut (25). Note: Do
not overtighten the Nut; the Wheel should turn freely.
Next, tip the Uprights (99) forward slightly, and insert a
Wheel Housing (43) into the base of one of the Uprights
as shown.
Attach the other Wheel (not shown) and Wheel Housing
(not shown) as described above.
99
92
93
43
25
3
4. With the help of a second person, carefully lower the
Uprights (99). Make sure that the Wheel Housings (43)
remain in the bases of the Uprights.
Attach each Wheel Housing (43) with a 1” Tek Screw (98).
Attach a Base Pad (97) to the base of each Upright (99)
with a 1” Tek Screw (98).
With the help of a second person, carefully raise the
Uprights (99) back to the vertical position.
43
98
98
99
97
4
2. Insert the excess Wire Harness (22, 61) down into the
right Upright (99).
Set the console assembly on the Uprights (99). While a
second person holds the console assembly, attach the
console assembly with four Console Bolts (86) and four
Star Washers (88) as shown.
Start all four Console
Bolts and then firmly tighten them.
Console
Assembly
88
22, 61
88
86
86
99
99
2