Pyramid Technologies 4000HD - Manual (Page 4)

the unit off a generator/inverter, use the UP or DOWN key to
change the TIME STD to CRYSTAL which will cause the unit to
keep time using an internal device.)
5. OFF- Unit will not adjust time for daylight saving time.
DSPLY FMT=AM/PM – Selects how the time will be displayed on the front
of the unit. Using the UP or DOWN keys, select one of the following
options:
1. AM/PM - Standard time (1-12 hours).
2. MIL - Military time (0-23 hours).
PRINT FMT=AM/PM – Selects how time will be printed on the time card.
Using the UP or DOWN keys, select one of the following options:
1. AM/PM - Standard time (default setting) (i.e. 3:30 PM).
2. MIL- Military time (i.e. 3:30 PM = 15:30).
3. ATAAP-Military time with minutes expressed in hundredths of
hour (i.e. 3:30 PM = 15.50).
SET HOUR – Sets the current hour of day by using the UP or DOWN key.
SET MINUTES – Sets the current minute of day by using the UP or
DOWN key.
BELL SET-UP
The internal buzzer is intended for quiet areas. To adjust the volume of
the internal buzzer, open the front cover and turn volume control on the
left side of the circuit board clockwise to increase volume or counter
clockwise to decrease volume.
External bells or buzzers can be added by purchasing a Model 5300 Bell
Ringer. The Bell Ringer can ring up to 15 bells or horns with 50 events.
Please refer to Optional Supplies and Accessories table located at the
end of this booklet. To connect the 5300 Bell Ringer to the 4000/4000HD
Time Recorder, plug the RJ-45 cable into jack on the left side of the Time
Recorder. Connect the other end of the cable to the Model 5300. The
wall transformer provided with the 5300 must be connected to the
recepticle labeled POWER . Wire your bells/ horns to the labeled
terminals on the 5300. The Bells/Horns must be wired in parallel as
shown, not in series: