Polycom DOC2564A - Manual (Page 2)

2
Preparations
Obtain the following information from your network administrator:
•
IP addresses, Subnet Mask and Default Gateway IP address
(optional) for the RMX control unit and RMX Shelf Management.
• IP addresses for the RMX Signaling Host and Media cards.
• Gatekeeper IP address.
• SIP server IP address, if applicable.
If ISDN/PSTN is installed in your conferencing environment, obtain the
following information from your ISDN/PSTN Service Provider:
•
Switch Type, Line Coding and Framing, Numbering Plan and
Numbering Type.
• Dial-in number range .
Unpacking the RMX
1 When you receive the RMX packing case, inspect the equipment for
damage and verify that the components match the packing slip.
2 The RMX is shipped in a packing case with Stratocell® packaging,
and the top cover must be unlocked and lifted.
3 Remove the boxes that are placed on the top Stratocell® and the top
Stratocell® and open the anti-static plastic bag wrapping the RMX.
4 Holding the handle on each side, lift the RMX from the box, and
place it on a flat surface or in a rack. Remove any packaging
material prior to positioning the RMX.
If the RMX is connected to the public ISDN Network, an external
CSU or similar equipment is needed.
Attention:
Two people are required to lift the MCU out of the box and when
installing it in a rack.
Write down the RMX’s serial number that is on a sticker on the back
of the unit. It will be needed for product registration later in the
installation process.