Paradyne 6342 - Manual (Page 23)

2. Accessing the DSL Router
6300-A2-GB20-10 November 2003 2-5
3. To create a login ID and password for a specified access level, enter:
telnet name create level login ID password
Example: Type telnet name create operator 238clrd3 1234
and press Enter.
NOTE:
Login ID and password are NOT case-sensitive. See Step 7 on page 2-3
for list of invalid characters.
4. Enable Telnet login so that the ReachDSL Router will perform login and
password validation for the Telnet session connection. Enter:
telnet login enable
save
NOTE:
Any input during an Administrator configuration session must be saved
while still in configuration mode.
Determining the Current Access Level
The command line prompt displays the access level. The factory default for
System identity is CUSTOMER>. You can set your own system identity name to
replace CUSTOMER. See the examples below.
Determining the Available Commands
To determine the commands available at the current login access level, enter any
of the following:
„ help
„ ? (question mark)
„ the command, without any parameters
If the prompt format
appears as . . .
Or, if a System identity of
PARADYNE is entered, the
prompt displays . . .
Then the DSL router
access level is . . .
CUSTOMER> PARADYNE> Operator, display mode
CUSTOMER #> PARADYNE #> Administrator, display
mode
CUSTOMER – CONFIG#> PARADYNE – CONFIG#> Administrator,
configuration mode