Planar PT1501MX - Manual (Page 13)

11
Connecting the Display (Figure 11.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the AC power cord to the power connector on the monitor and the
other end into an electrical outlet (11.1).
3. Connect the D-SUB cable from the display’s VGA input connector to the
D-SUB connector of your host computer and tighten the screws (11.1).
4. Connect the Audio-In cable from the audio input port of your display to the
Audio-out port of your computer (11.1).
5. Connect the RS-232 or USB cable from the RS-232 or USB port of your
display to the RS-232 port (11.1) or USB port (11.1) of your computer.
6. Configure the touch screen. Refer to the “Touch Screen Driver
Installation section on Page 20.
7. Once the touch screen is configured, the monitor is ready for use.
Instructions to attach the magnetic stripe reader to the PC (PT1550MX
and PT1555MU models)
1. Attach the USB Type A to A cable to the magnetic stripe reader.
2. Route the cable through the cable management opening in the desk stand
with the other monitor cables.
3. Plug the cable into the PC.
4. No driver is necessary.