Basic functions, Plug and play (for tuner installation), Demonstration mode – Philips FWD570 User Manual

Page 18

Advertising
background image

18

English

Basic Functions

Plug and Play (for tuner installation)

Plug and play allows you to store all available
radio stations automatically.

If plug and play has not been installed

1

When you turn on the system, “

AUTO

INSTALL- PRESS PLAY” will be displayed.

2

Press

38 on the system to start installation.

INSTALL” will be displayed and followed by

TUNER” and then “AUTO”.

PROG will start to flash.

The system will search all radio stations on

the FM band, and then the MW band.

All available radio stations with strong signal

strength will be stored automatically.

The system will stop searching when all

available radio stations are stored or when the
memory for 40 preset radio stations is full.

The first preset radio station will play when

Plug and Play is completed.

Reinstalling plug and play

1

In Standby or Demonstration mode, press and
hold

38 on the system until “AUTO

INSTALL-PRESS PLAY” is displayed.

2

Press

38 again to start installation.

All previously stored radio stations will be

replaced.

To exit without storing the plug and play

Press

7 on the system.

Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If Plug and Play installation is not completed, it
will be reinitiated the next time you power on the
system.
– If there is no antenna connected, “

CHECK

ANTENNA” will scroll on the display.
– If auto-install is not preset, the system will store
the radio station automatically.

Demonstration mode

The system has a demonstration mode that
shows various features offered by the system.

Activating demonstration

In Standby or ECO power mode, press and hold
DEMO•STOP

7 for more than 5 seconds to

activate demo mode.

DEMO ON” is displayed.

Demonstration will begin.

Deactivating demonstration

Press and hold

DEMO•STOP

7 on the system

until “

DEMO OFF” is displayed.

The system will switch to Standby mode.

Note:
– Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration
will remain off until you activate it again.

Advertising