ProForm PFEX39912 User Manual
Page 8
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to page 18), follow the steps below to install the receiver
and the short jumper wire included with the chest pulse sensor.
1. Remove the two short screws and the two long screws
from the back of the Console (16). Lift off the front of
the Console.
2. Plug the short jumper wire (A) into the indicated jack on
the Console (16). Connect the other end of the short
jumper wire to the wire on the receiver (B). Note: Any
other wires included with the chest pulse sensor can be
discarded.
Next, peel the paper off the adhesive pad on the back
of the receiver (B). Orient the receiver as shown, and
press it onto the Console (16) in the indicated location.
Refer to step 1 above. Reattach the front of the
Console (16) with the short and long screws. Make
sure that no wires are pinched.
8
B
16
Jack
16
Short
Screws
Long
Screws
Lift
Here
1
A
Cylinder
2