Panasonic WV-CW484 - Manual (Page 41)

41
• Image stabilization may not function where there is excessive camera movement or when
the scene is low light or low contrast objects.
16. LENS
• When using WV-CW484F or WV-CW484S (with a Panasonic x2 varifocal lens), select
PANASONIC.
• When using WV-CW484FK or WV-CW484SK (with a lens other than Panasonic), select
OTHER.
17. Back-focus Setting (BACK-FOCUS SETUP)
If applicable, perform adjustment of the lens
focus as described in p. 26 "Before Back-focus
Adjustment" on the INSTALLATION page.
Perform adjustment of the back focus (flange-
back: the gap between the lens and focal plane)
remotely on this menu using a system controller.
After installation, you can perform this adjustment
when defocus arises that may be caused by
long-term use, environmental changes, etc.
Important: Do not use the ABF function for continuous or repetitive purposes (ex. autofocus
etc.). This function is to be used to correct defocus caused by switching between color and
black - and - white when/after installing the camera.
1. Select BACK-FOCUS on the WV-CW484 TOP menu and press SET.
→ The BACK-FOCUS SETUP menu opens.
2. Select ABF and press SET.
→ Adjustment is automatically performed.
Notes:
• Performing ABF will function to obtain the best focus around the center areas in a
scene.
• Performing ABF is available only when OFF, X2 AUTO, or X2 FIX is selected for SENS
UP.
3. Select MANUAL-ADJ and press SET if manual adjustment is required.
The manual back-focus adjustment screen will open.
• Use the [LEFT] and [RIGHT] buttons for 2 seconds or more to move the "I" cursor and
obtain a proper focus.
→ Refer to the 4-digit number on the second bottom line. The larger the number is, the bet-
ter the focus will be.
• Select RET and press SET to go back to the menu setup.
**BACK-FOCUS SETUP**
ABF
→PUSH SW
MANUAL-ADJ
C/L
← → B/W AUTO
SETUP-SW LOCK OFF
NEAR FAR
.........I.........
INDICATOR XXXX
RET TOP END
↵