Maintenance, Lights – Polaris Hawkeye 922362 User Manual

Page 86

Advertising
background image

83

MAINTENANCE

Lights

Headlight Beam Adjustment

The headlight beam can be adjusted slightly upward or downward. Use

the following procedure to make the adjustment.

1. Position the vehicle on a level surface with the headlight approxi-

mately 25 ft. (7.6 m) from a wall.

2. Place the transmission in neutral.
3. Lock the parking brake.
4. Measure the distance from the floor to the center of the headlight

and make a mark on the wall at the same height. Include rider

weight on the seat when measuring.

5. Start the engine.Turn the headlight switch to high beam.
6. Observe the headlight aim on the wall. The most intense part of the

headlight beam should be two inches (5 cm) below the mark on the

wall.

7. Loosen the phillips screw at the rear of the headlamp.
8. Adjust the beam.
9. Tighten the screw.

25 ft.

(7.6 m)

2" (5 cm)

Advertising
This manual is related to the following products: