ProForm 625 EX - Manual (Page 5)

5
1. Refer to the drawing on page 4 and identify the
right side of the treadmill. With the help of a second
person, carefully lay the treadmill on its right side.
Firmly slide an Extension Leg (59) into one side of the
Base (32). Make sure that the Extension Leg is turned
so the bracket is on the side shown. Using the Allen
Wrench (102), tighten an Extension Leg Screw (57) into
the Extension Leg and the Base. Without turning the
treadmill over, attach the other Extension Leg in the
same manner.
Stand the treadmill upright so that both Extension Legs
(59) are resting flat on the floor.
57 102
59
32
Bracket
1
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Without removing the tape from the Latch (34), hold the
Latch against the left Upright (32) as shown. Attach the
Latch to the left Upright with four Screws (33). Make
sure that the Screws are tight, but do not over-
tighten them; if the Screws are overtightened, the
Latch will not slide smoothly. After the Latch is at-
tached, remove any visible tape.
Note: The inset drawing shows how the parts of the
Latch (34) fit together.
34
33
33
32
2
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dis-
pose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver , adjustable wrench , and scissors .
Spacer
Springs
Bracket
Latch
3. Cut the plastic tie holding the cage nut in the upper end
of the Left Handrail (60).
Position the Left Handrail (60) on the left Upright (32) as
shown. The bracket on the Extension Leg (59) should
be inside of the lower end of the Left Handrail. Thread
a Handrail Bolt (30) with a Handrail Washer (31) into the
left Upright and the Left Handrail. Do not tighten the
Handrail Bolt yet.
60
30
31
32
59
3