Panasonic CY-VHD9500U - Manual (Page 26)

78
CY-VHD9500U CY-VHD9500U
79
Other (USER) Settings
Note:
≥ If no operation takes place for more than
10 seconds, the display exits the menu.
1
Menu
Video Control Setting
This “Video Control Setting” is required
when you connect a Panasonic car
navigation system with a built-in DVD
player (available in future).
Default: VTR1
Setting range: VTR1, VTR2
3
Setting
E
N
G
L
I
S
H
35
E
N
G
L
I
S
H
36
Button Operation Sound
Default: ON
Setting range: ON/OFF
Blue Ceiling Refl ected
Illumination Setting
Default: ON
Setting range: ON/OFF
Audio Output Level
Default: 3
Setting range: 1/2/3
1 Press [MENU]
to display the menu.
2 Press [%] or [$]
to select “USER”.
USER
VIDEO-CONT
BEEP
LIGHT
OUTPUT LEVEL
2
Submenu
Select
Select
Select
Select
Select
1 Press [%] or [$] to adjust.
2 Press [ENTER] to set.
3 Press [SRC] (Source) to exit the menu.
ON: Operation sound (Beep) ON
OFF: Operation sound (Beep) OFF
ON: Blue ceiling refl ected illumination lights.
OFF: Blue ceiling refl ected illumination lights off.
1: Minimum level
2: Middle level
3: Maximum level
1 Press ["] or [#]
to select the item.
2 Press [ENTER].
VTR1: Connected to the VTR1-IN
VTR2: Connected to the VTR2-IN
Memory Clear
Default: NO
Setting range: YES/NO MEMORY CLEAR?
Select
YES: Default settings
NO: No memory clear
The display returns to the previous one.
SCREE SCREEN N USER USER
V I DEO-C
O-CONT
BEEP
L I GHT
HT
OUTP UTPUT T LEVEL EL
MEMORY ORY CLEAR? AR?
: SELECT ENTER:SEL
SOURCE : END ENTER: SET
SCREE SCREEN N USER USER
: SELECT
VTR TR VTR VTR2
[MENU]
[ENTER]
[
"] [#]
[ %] [$]
[SRC] (Source)
Note:
≥ In the SD mode, SETUP MENU settings are not
returned to the default settings even when YES
is selected as this setting.
Note:
≥ Select a terminal connected to the DVD output terminal of a Panasonic car navigation system with a
built-in DVD player (available in future) through an RCA cord.
≥ When you coonect a Panasonic car navigation system with a buit-in DVD player, connect a video
control lead as well.
Note:
≥ The sound may be distorted depending on the
input sensitivity of the external device connected.
Proceed with an adjustment only if this is the
case. Normally, keep at the default setting.