Panasonic Integrated Telephone System KX-TS550B - Manual (Page 2)

5 Special Features
5-A For Call Waiting Service Users
5-B Temporary Tone Dialing
(For Rotary or Pulse Service Users)
Press
(FLASH) if you hear a call-waiting tone
while talking.
≥ The first call is put on hold and you can answer the
second call.
≥ To return to the first caller, press (FLASH) again.
Press ($) (TONE) before entering access
numbers which require tone dialing.
≥ The dialing mode changes to tone. You can enter
numbers to access answering services, electronic
banking services, etc. When you hang up, the mode
will return to pulse.
≥ Access numbers entered after pressing ($) (TONE)
will not be included when redialing.
5-C Using the PAUSE Button
(For PBX Line/Long Distance Calls)
We recommend you press (PAUSE) if a pause is
required to dial with a PBX or to make a long
distance call.
Ex. Line access number (9) (PBX)
(9) ¤ (PAUSE) ¤
≥ Pressing (PAUSE) once creates a few seconds
pause. This prevents misdialing when you redial or
dial a stored number.
≥ Pressing (PAUSE) more than once increases the
length of the pause between numbers.
Phone number
6 Things You Should Know
“ Things You Should Know
6-A Wall Mounting
1
Press the tabs in the
direction of the arrows
(1), then remove the wall
mounting adaptor (2).
2
11 1
2
Tuck the telephone line
cord inside the wall
mounting adaptor, and
push it in the direction of
the arrow (1 and 2).
≥ The word “UP WALL”
should face upward.
1
2
3
Connect the telephone line cord. Mount the
unit, then slide down.
≥ Fasten the cord to prevent it from being
disconnected.
Wall Phone
Plate
Hooks
To temporarily set the
handset down during a
conversation, place it as
shown here.
The unit can be mounted on a wall.
6-B Troubleshooting
Problem
The unit does
not work.
The call cannot
be connected
even if you
dialed correctly.
The unit does
not ring.
You cannot
store a phone
number in
memory.
Remedy
≥ Check the settings
(1-B).
≥ Check whether the
DIALING MODE selector
setting is correct or not
(1-B).
≥ The RINGER selector is
set to OFF. Set to HIGH
or LOW (1-B).
≥ Confirm the handset is off
the cradle.
≥ Do not enter a phone
number more than 21
digits long, or the entered
number and the
previously stored number
will be cleared.
Problem
The other party
suddenly cannot
hear your voice
during a
conversation.
You cannot
redial by
pressing
(REDIAL).
If you cannot
solve your
problem
Remedy
≥
(PROGRAM) was pressed
during the conversation.
Press
(PROGRAM) again.
≥ If the last number dialed
was more than 31 digits
long, the number will not
be redialed.
≥ Call our customer call
center at
1-800-211-PANA(7262).
≥ Panasonic’s e-mail
address for customer
inquiries:
[email protected]
for customers in the USA
or Puerto Rico ONLY
When you ship the product
≥
Carefully pack your unit, preferably in the original
carton.
≥ Attach a letter, detailing the symptom, to the outside
of the carton.
Symptom
≥ Send the unit to an authorized servicenter, prepaid
and adequately insured.
≥ Do not send your unit to the Panasonic Consumer
Electronics Company listed on the back cover or to
executive or regional sales offices.
These locations do not repair consumer products.
≥ Environment—do not place the unit in a room where
the temperature is less than 5°C (41oF) or greater
than 40°C (104oF). Allow 10 cm (4q) clearance around
the unit for proper ventilation. Avoid excessive smoke,
dust, mechanical vibration, shock, or direct sunlight.
≥ Routine care—wipe the unit with a soft cloth. Do not
use benzine, thinner, or any abrasive powder.
≥ If there is any trouble—disconnect the unit from the
telephone line and connect a known working phone. If
the known working phone operates properly, have
your unit repaired by one of the authorized Panasonic
Factory Service Centers. If the known working phone
does not operate properly, consult your telephone
company.
For product service
≥
Call 1-800-211-PANA(7262) or 1-800-833-9626 for
the location of an authorized servicenter.
≥ Panasonic’s e-mail address for customer inquiries:
[email protected]
for customers in the USA or Puerto Rico ONLY
6-D Helpful Information
6 Things You Should Know
“ Things You Should Know
6-C Specifications
Power Source: From telephone line
Dimensions (H x W x D):
Approx. 96 mm x 150 mm x 200 mm
(3 25 ⁄
32 q k 5 29 ⁄
32 q k 7 7 ⁄
8 q )
Mass (Weight): Approx. 495g (1.09 lb.)
Dialing Mode: Tone (DTMF)/Pulse
Operating Environment: 5°C–40°C (41oF–104oF)
Specifications are subject to change without notice.
For assistance, please call: 1-800-211-PANA(7262) For assistance, please call: 1-800-211-PANA(7262) For assistance, please call: 1-800-211-PANA(7262)
7 Referencia Rápida
“ Referencia Rápida
7-A Pasos Iniciales
Cordón del auricular
Auricular
Cable de la línea telefónica
Selector del
RINGER
Selector del
DIALING MODE
1
2
A toma de teléfono de
una sola línea (RJ11C)
TONE PULSE
DIALING MODE
HIGH OFF
RINGER
7-B Haciendo Llamadas
7-C Contestando Llamadas
1
Conecte el cable de la línea telefónica (1).
2
Conecte el cordón del auricular (2), luego
confirme el tono para marcar.
3
Coloque el selector del DIALING MODE a
TONE (tono).
≥ Si Ud. no puede marcar colóquelo en PULSE
(pulso)
.
4
Coloque el selector del RINGER a HIGH
(alto), LOW (bajo) u OFF (apagado).
(Ej. se selecciona “HIGH”.)
≥ Cuando esté colocado en OFF, la unidad no
sonará.
1
Cuando la unidad suene, levante el auricular.
2
Cuando termine de hablar, cuelgue.
1
Levante el auricular.
2
Marque el número de teléfono.
≥ Si Ud. se equivoca al marcar, cuelgue y comience
de nuevo desde el paso 1.
3
Cuando termine de hablar, cuelgue.
Para remarcar el último número marcado
Levante el auricular.
¤ Presione (REDIAL).
≥
(REDIAL) marcará el último número que se introdujo
manualmente, no llamará a un número de marcación
rápida (3-B) ni a un número de marcación de un solo
toque (4-B).
Para ajustar el volumen del auricular
(6 niveles) mientras habla
Para aumentar, presione
(^).
Para disminuir, presione (_).
≥ Cada vez que Ud. presione el botón, el nivel del
volumen cambiará.
≥ Después de colgar, el nivel del volumen se guardará.