Philips e7000 - Manual (Page 8)


Using the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces Sonicare’s effectiveness in removing plaque.
The Easy-start feature should be deactivated when Sonicare is used in
clinical trials.
Smartimer
\ 2-minute timer
All Sonicare models come with the Smartimer feature, which
automatically sets the brushing time to the 2 minutes recommended
by dental professionals.
After 2 minutes, your Sonicare will automatically turn off the
toothbrush.
If you wish to pause or stop brushing during your 2-minute cycle,
press the power button. Press the power button again and the
Smartimer will pick up where you left off.
Note: The Smartimer will automatically reset to the beginning of a 2-minute
cycle if:
brushing is paused for 30 seconds or longer;
the handle is returned to the charger.
Quadpacer \ 30-second interval timer
Quadpacer makes sure that you brush all sections of your mouth
evenly and thoroughly. When using a two-minute brushing cycle, you
will hear a short beep and a pause in brushing action at 0, 0 and
90 second intervals.
Programmable Quadpacer timer (select models only)
The Programmable Quadpacer timer offers you the option of customizing
the Quadpacer performance in 1 of 3 ways:
You may opt to keep the factory default setting of a 2-minute
brushing time with Quadpacer feature activated.
You may choose to extend your brushing time to 2 1/2 minutes by
adding an additional timing interval of 0 seconds with Quadpacer
feature active.
You may choose a 2-minute brushing time, but with the Quadpacer
feature turned off.
To change the Quadpacer settings:
1 Place the handle in the charger that is plugged into a live electrical
outlet.
 Press the Dual Speed Control button briefly and note which LED
lights up.
 Press and hold the Dual Speed Control button. Continue to hold
the button while the LEDs slowly cycle through the timing interval
setting options.
,
,
,
-
-
,
,
,
,
1
3
1
3