Panasonic KX-T7775 - Manual (Page 3)

3
14
Specifications
Power:
AC Adaptor Input/Output:
120 V AC 60 Hz/24 V DC, 300 mA
Power Module Input: 24 V DC
Output: 17 V at 60 mA DC
Doorphone (DP) Input: 17 V at 60 mA DC
Cable Diameter/Length: 0.4mm 2 - 210 m (AWG 26 - 689 ft)
0.5mm 2 - 340 m (AWG 24 - 1115 ft)
0.6mm 2 - 500 m (AWG 22 - 1640 ft)
Illuminated Button: Yes
Surface-mountable: Yes
Recess mountable: Yes
Connections:
Power Module: RJ11 Input
from PBX Doorphone Card
DC Input Power Supply DC +24 V
Terminal Block Output Door 1 to KX-T7775
Doorphone: Terminal Block Input Door 1
Terminal Block Output Doorbell In
Doorbell Out
Dimensions (H x W x D): 130 mm x 85 mm x 51 mm
(5 / " x 3 / " x 2")
Weight: 0.4 kg (0.89 lb)
Note: Specifications are subject to change.
Location
n Exposure to direct sunlight can result in the discoloration of the
Doorphone Unit.
n The Doorphone Unit can be mounted externally and is weather-
resistant, but it should not be subjected to direct contact with water.
n Maximum operating temperature range is -20°C to +50°C
(-4°F to +122°F).
n When inserting screws avoid pipes and electrical cables, etc, that
may be present/buried.
AWG 26 (0.4mm 2 - 210m)
AWG 24 (0.5mm
2 - 340m)
AWG 22 (0.6mm
2 - 500m)
1 3 8 8
FCC and Other Information
Note:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
n
Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and receiver.
n
Connect the equipment into an outlet or a circuit different from that
to which the receiver is connected.
n Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAUTION:
Any changes or modifications made to this product not expressly
approved by Panasonic Communications Co. Ltd. could void the user's
authority to operate the equipment.