Panasonic RQT4912-2P - Manual (Page 5)

5
RQT4912
Putting the player together
Put the player together in the following order.
•Do not connect the AC power cord until set up is complete.
•Leave the dust cover off until set up and adjustments are com-
plete.
Fit the turntable and turntable mat .
Put the turntable on the center spindle and then lay the mat on
top.
•Be very careful when putting the turntable on the main unit.
The magnet on the bottom of the turntable is finely adjusted
and sharp contact can cause it to move and lead to poor op-
eration. Ensure the magnet remains free from dust and iron
particles.
•Do not adjust the screws attaching the magnet to the turn-
table. The rated performance of the unit cannot be guaran-
teed if the magnet is moved.
Attach the head shell .
Fit the head shell into the tone arm, keep it horizontal and tighten
the locking nut.
Attach the balance weight to the rear of the
tone arm.
If the cartridge weighs between 10 and 13 grams, attach the
included auxiliary weight
to the main balance weight.
When the player is to be used for scratch play
Use the disc slip sheet instead of the turntable mat. This enables
the record to be easily moved during play.
•Top (printed side): Lay the record on this side.
•Bottom: Slippery side.
For a different kind of slip
Put the transparent sheet under the disc slip sheet.
Locking nut
Magnet
Securing
screws