Pioneer MILESTONE 12 - Manual (Page 75)

75
Speaker System: PDP-S55-LR
5 Tighten the screws just inserted firmly into place (four
locations).
¶ Tighten the screws while pushing the speakers
lightly against the Plasma Display. Check to be
sure that all four screws have been screwed
firmly into place.
¶ If there is a large gap between the Plasma
Display and the speakers, adjust them after
slightly loosening the screws that were tightened
in step 2. After adjustment, re-tighten the
screws.
¶ To install the Plasma Display on a wall, it is
recommended that you first remove the speaker
units, then after the Plasma Display has been
installed on the wall, re-attach the speaker units
to the Plasma Display.
Warning
¶ Never hold the speakers when speakers are attached
to the monitor to move the monitor. Doing so might
result in the monitor falling, and this in turn might
result in bodily injury.
¶ Firmly tighten the screws. The speakers may fall
causing injuries.
2) Connect the cords
(Turn off the power of all connected units before
connecting the cords.)
Use the provided speaker cords to connect the R/L
speaker jacks of the monitor to the speaker jacks of the
speakers.
Once the cords have been connected, pull on the cords
lightly to make sure that they have been connected firmly
to the speaker jacks. An improper connection might re-
sult in the sound being interrupted or the appearance of
noise in the output sound.
Cord clampers
Remove the seal from the rear of the cord
clampers, attach the clampers in the desired
position, and clamp the cords into place.
Red
Black
Press the button of the speaker jack and keep it
pressed down as you insert the wire of the speaker
cord and then release the button.
Note that the speaker cords have positive and
negative ends, and that you should be sure to
insert them correctly.