ProForm C55 PFEX35430 - Manual (Page 8)

8
10. Firmly tighten the four M8 x 31mm Button Bolts (80)
in the Seat Carriage (11). Note: There are two
Button Bolts in each side.
Pull the seat knob and slide the Seat Carriage (11)
to the desired position. Release the seat knob, and
slide the Seat Carriage back and forth slightly
until it locks into position. Make sure to regularly
tighten the four M8 x 31mm Button Bolts (80).
11. Identify the Right Pedal (37), which is marked with
an “R.” Using an adjustable wrench, firmly tighten
the Right Pedal clockwise into the right arm of the
Crank (19). Tighten the Left Pedal (not shown)
counterclockwise into the left arm of the Crank (not
shown).
After using the exercise cycle for one
week, retighten the Pedals.
Attach the Right Pedal Strap (38) to the Right Pedal
(37). Press the end of the Right Pedal Strap onto
the tab on the Right Pedal. Attach the Left Pedal
Strap (not shown) in the same way.
11
80
19 38
37
Tab
10
12. Make sure that all parts are properly tightened before you use the exercise cycle. Place a mat
beneath the exercise cycle to protect the floor.
9. Pull the seat knob and slide the Seat Carriage (11)
onto the Seat Rail (7).
See the inset drawing. Hold the Bumper Axle (73)
inside of the Seat Rail (7). Attach the two Bumpers
(65) to the ends of the Bumper Axle with two M6 x
16mm Screws (62) and two M6 Washers (25) as
shown. Press the Seat Rail Endcap (23) into the
end of the Seat Rail.
11
Knob
7
9
23
73
62
65
25
7
8. Attach the Backrest (13) to the Seat Carriage (11)
with four 1/4” x 38mm Hex Screws (78) and four M6
Washers (25).
13
25
11
25
78
8
Knob
65
62
11
25