Polaris 600 Fusion - Manual (Page 60)

57
THE PERFECT FIT
FAST M-10 Rear Suspension Adjustments
Ski Pressure
4. There are also two front
arm mounting holes in
the slide rail that can
adjust ski pressure. The
lower hole (1) increases
ski pressure while the
upper hole (2) decreases
ski pressure.
NOTE: By design, the BIASED COUPLE design of the M-10 suspen-
sion displaces the rear arm as the front arm is compressed.
This means that when you raise the front limiter strap, at some
point you will collapse the rear suspension arm, which will
affect SAG height and reduce rear suspension travel.
Initial M-10 Suspension Set-up Chart
NOTE: The initial M-10 suspension set-up chart was not available at
the time of printing. Please see your Polaris dealer.
1
2