Panasonic WV-Q151S - Manual (Page 5)

9 8
10. Install the inner shell.
Slide the covers located on the both lat-
eral sides of the camera and put the
inner shell on the camera until the hooks
inside the inner shell are held in the
holes of the camera (until a click is
heard).
Important: Put the inner shell down on
the camera until the outside cover of
the camera cannot be seen from the
opening (from which the camera
lens is visible) of the inner shell. If
this integration is not successfully
performed, the inner shell may be
removed or the hidden part at the
top of the screen may become larg-
er in the WIDE mode.
How to remove the inner shell
Press the inner shell from the front and rear
sides inward (at the same vertical position as
the hooks) to bend the shell and remove the
shell from the camera.
Cover
Hook
Put on until a click is
heard
Press from the front and rear
sides inward to bend
Inner shell
Ceiling board
fixing screw
Ceiling
board fixing
bracket
Insert the anchor bolt Nut
Double nuts
Turn counterclockwise
7. Insert the mounting base into the hole
made in Step 1.
8. Secure the mounting base to the ceil-
ing board with the ceiling board fixing
screws (4 positions).
q Engage the top of the mounting base
with the 1st anchor bolt.
w Secure the mounting base with dou-
ble nuts.
e Secure the mounting base by turning
the ceiling board fixing screws clock-
wise.
Turning the ceiling board fixing
screws clockwise provides ceiling
board tightening between the bottom
of the mounting base and ceiling
board fixing bracket resulting in
mounting base securing.
(Recommended tightening torque:
3.1 N·m {30.5 k
gf·cm})
9. Prepare the cables.
Run the cables from the cable inlet.
Important: The cables shall be run from
the opposite side of the mark,
FRONT. Failure to observe this
makes the cables unconnectable.
F R O N T
Cable inlet
1st anchor bolt
Ceiling board