Panasonic SCPM533 - Manual (Page 15)

RQTV0097
15
ENGLISH
English
English
Specifi cations
AMPLIFIER SECTION
FTC OUTPUT POWER both channel driven
simultaneously
10% Total harmonic distortion
60 Hz to 3 kHz
(Low
channel) SC-PM53 40 W per channel (6 Ω)
SC-PM533 38 W per channel (6 Ω)
3 kHz to 16 kHz
(High channel)
SC-PM53 39 W per channel (6 Ω)
SC-PM533 36 W per channel (6 Ω)
Total Bi-Amp power SC-PM53 79 W per channel
SC-PM533 74 W per channel
RMS OUTPUT POWER both channel driven
simultaneously
10% total harmonic distortion
1 kHz
(Low
channel) SC-PM53 45 W per channel (6 Ω)
SC-PM533 43 W per channel (6 Ω)
8 kHz
(High channel)
SC-PM53 45 W per channel (6 Ω)
SC-PM533 42 W per channel (6 Ω)
Total Bi-Amp power SC-PM53 90 W per channel
SC-PM533
85 W per channel
Input Impedance
Music port 250 mV 12 kΩ
Output Impedance
Headphone 16 Ω to 32 Ω
Phone jack
Terminal Stereo, 3.5 mm ( 1 /
8
")
Music port input jack
Terminal Stereo, 3.5 mm ( 1 /
8
")
FM TUNER SECTION
Frequency range
87.9 MHz to 107.9 MHz (200 kHz steps)
87.5 MHz to 108.0 MHz (100 kHz steps)
Sensitivity 0.3 µV (IHF)
S/N 26 dB 0.2 µV
Antenna terminals 75 Ω (unbalanced)
Preset station FM 15 stations
AM 15 stations
AM TUNER SECTION
Frequency range 520 kHz to 1710 kHz (10 kHz steps)
Sensitivity
S/N
20 dB (at 1000 kHz) 900 µV/m
CASSETTE DECK SECTION
Track system 4-track, 2-channel
Heads
Record/playback
Solid permalloy head
Erasure Double gap ferrite head
Motor DC servo motor
Recording system AC bias 100 kHz
Erase system AC erase 100 kHz
Tape speed 4.8 cm/s (1 7 /
8
ips)
Overall frequency response (+3, –6 dB at DECK OUT)
NORMAL
35 Hz to 14 kHz
S/N RATIO 54 dB (A weighted)
Wow and fl utter 0.08% (WRMS)
Fast-forward and rewind time
Approx. 120 seconds with C-60 cassette tape
CD SECTION
Disc played [8 cm (3") or 12 cm (5")]
(1) CD-Audio (CD-DA)
(2) CD-R/RW (CD-DA, MP3, WMA formatted disc)
(3)
MP3/WMA
Sampling frequency
CD-DA 44.1 kHz
MP3/WMA 32 kHz, 44.1 kHz, 48 kHz
Bit rate
MP3/WMA 32 kbps to 384 kbps
Decoding 16/20/24 bit linear
Pick up
Wavelength
785 nm
Beam source Semiconductor laser
Laser power CLASS 1
Audio output (Disc)
Number of channels 2-Channel
Frequency response 20 Hz to 20 kHz (+1dB, -2 dB)
Wow and fl utter Below measurable limit
Digital fi lter 8 fs
D/A converter MASH (1 bit DAC)
SPEAKER SECTION
Type 2 way, 2 speaker system
Speaker(s)
Woofer 10cm (4˝) cone type (6 Ω)
Tweeter 6 cm (2 3 /
8
˝) cone type (6 Ω)
Impedance 6 Ω
Input power (IEC)
HIGH 90 W (Max)
LOW 90 W (Max)
Output sound pressure
80 dB/W (1.0 m)
Crossover over frequency 2.2 kHz
Frequency range 45 Hz to 35 kHz (-16 dB)
50 Hz to 31 kHz (-10 dB)
Dimensions (W x H x D) 144 mm x 249 mm x 200 mm
(5 11 /
16
˝ x 9 13 /
16
˝ x 7 7 /
8
˝)
Mass 1.9 kg (4.2 lb.)
GENERAL
Power supply AC 120 V, 60 Hz
Power consumption 140 W
Dimensions (W x H x D) 175 mm x 249 mm x 355 mm
(6 7 /
8
˝ x 9 13 /
16
˝ x 13 63 /
64
˝)
Mass 5.4 kg (11.9 lb.)
Operating temperature range
+5°C to +35°C (+41°F to +95°F)
Operating humidity range
5% to 90% RH (no condensation)
Power consumption in standby mode 0.4 W
Note
1. Specifi cations are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer.
3. The labels “HIGH” and “LOW” on the rear or the speakers refer to
High frequency and Low frequency.
Maintenance
If the surfaces are dirty If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this
unit.
• Before using chemically treated cloth, read the instructions
that came with the cloth carefully.
For a cleaner, crisper sound For a cleaner, crisper sound
Clean the heads regularly to assure good quality playback
and recording.
Use a cleaning tape (not included).
When moving the unit
1 Remove all discs.
2 Press [POWER y/I] to turn the unit off.
3 Disconnect the AC power supply cord.
RQTV0097_2P_EN.indd 15 RQTV0097_2P_EN.indd 15 2/6/06 3:35:15 PM 2/6/06 3:35:15 PM